JTS IN-64TH Instruction Manual Download

Page: 10 / 20

5.1.2 Sensitivity

The microphone sensitivity can be adjusted in four
steps (0 dB, -6 dB, -12 dB or -18 dB).

1) Keep the button SET (6) pressed for approx. 2 sec -

onds until the display shortly shows

and then

the group adjusting mode (group indication , , or

will flash).

2) In the group adjusting mode, press the button SET

twice to go to the adjusting mode for the sensitivity.
The display will shortly show

and then the

sensitivity currently adjusted.

Note:

To exit the adjusting mode without making an

adjustment, press the button SET repeatedly until the
display shows

. The unit will then return to normal

operation.

3) Adjust the sensitivity with the arrow buttons in such

a way to obtain an optimum volume level of the
microphone: If the volume is too high, the micro-
phone will distort; in this case, adjust a lower value
with the button

(8). If the volume is too low, there

will be a poor signal-noise ratio; in this case, adjust
a higher value with the button

(7).

4) Confirm the selection with the button SET.

will be shortly displayed and the unit will go to nor-
mal operation.

5.1.3 REMOSET transmission

The REMOSET function (frequency adjustment of the
transmitter via a radio signal of the receiver) will be
activated/deactivated for the transmitter.

1) Keep the button SET (6) pressed for approx. 2 sec -

onds until the display shortly shows

and then

the group adjusting mode (group indication , , or

will flash).

2) In the group adjusting mode, press the button SET

three times to go to the adjusting mode for the
REMOSET transmission. The display will show:

with the REMOSET function activated

with the REMOSET function deactivated

Note:

To exit the adjusting mode without making an

adjustment, press the button SET repeatedly until the
display shows

. The unit will then return to normal

operation.

3) To deactivate the REMOSET function, press the

button

(8); to activate the REMOSET function,

press the button

(7).

4) Confirm the selection with the button SET.

will be shortly displayed and the unit will go to nor-
mal operation.

5.1.4 Identification number

To allow the REMOSET transmission between the
transmitter and the receiver, the identification numbers
of the units must be matched.

1) Keep the button SET (6) pressed for approx. 2 sec -

onds until the display shortly shows

and then

the group adjusting mode (group indication , , or

will flash).

2) In the group adjusting mode, press the button SET

four times to go to the adjusting mode for the iden-
tification number. The display will show

and the

identification number currently adjusted.

Note:

To exit the adjusting mode without making an

adjustment, press the button SET repeatedly until the
display shows

. The unit will then return to normal

operation.

3) To run through the adjusting range

…

, use the button

(7) for upward selection and

the button

(8) for downward selection. Use the

corresponding arrow button to adjust the same
identification number on the transmitter as on the
receiver (the transmitter will only respond to the
REMOSET signal of the receiver with the same
identification number) or select the adjustment

(the transmitter will then respond to the

REMOSET signal of any receiver).

4) Confirm the selection with the button SET.

will be shortly displayed and the unit will go to nor-
mal operation.

5.1.5 Lock function

In the factory, the lock function of the unit has been
deactivated.

When the lock function is activated, the frequency

adjustment via the REMOSET function will not be pos-
sible. Furthermore, it will not be possible to switch off
the transmitter: when the button

(4) is pressed, the

display will show

(„lock on“).

Activating the lock