JST
CMKS-L INDUSTRY STANDARD APPLICATOR
H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Applicators and Die sets\TS174-00
CMKS-L Manual.doc
2
For safe use
•
Always switch off the Press at the mains and remove the applicator from
the Press before making any adjustments or fitting new parts.
•
Always refer to this manual before making any adjustments to JST
Applicators
•
All JST Applicators are supplied with a Die-construction sheet; please
refer to this document when ordering spare parts.
•
All JST Industry standard Applicators have been designed to operate in
Industry standard presses with a shut height of 135.78mm. If you have any
doubt to whether our applicator is compatible with your Press please do not
hesitate to call our Technical Services Department where one of our
Engineers will be pleased to advise.
•
Do not modify or adapt the applicator without prior consent of JST.
•
Always ensure that safety guards are fitted to the Press when using your
JST applicator.
•
To prevent damage to the dies, always ensure that a protective rubber collar
is fitted between the dials and casting of the applicator when it is removed
from the press.
•
Do not make adjustments to the tooling unless qualified to do so.
•
When replacement parts are required, use only genuine JST supplied parts.
Die parts that are manufactured using an incorrect heat treatment process
can shatter during use.
