JST
CMKS-L INDUSTRY STANDARD APPLICATOR
H:\0 - Quality Documents\2 Department\Tech Serv\Application tooling\Applicators and Die sets\TS174-00
CMKS-L Manual.doc
13
10. ADDITIONAL INFORMATION
10.1 Wire Stop / Stripper
Depending on which terminal you are processing, a wire stop / stripper is sometimes
fitted to the die spacer The purpose of this part is to position the wire correctly prior to
crimping and remove the terminal from the crimp punches after the crimping process.
CAUTION
you must ensure that the stripper is set in a position behind the crimp
anvils and punches so that they will not come into contact and cause damage to the
tool.
10.2 Cam Roller and Cam Roller shaft
The Cam roller’s function is to move a long the Cam which in turn will move the Feed
finger into position, therefore, if there is any wear in this part or this part becomes
damaged then it will result in the terminal being positioned incorrectly.
Cam roller
Cam roller shaft
Stripper bracket (156)
Wire stop / Stripper
(155)
Die spacer (149)
