JRC JHS-32B, Instruction Manual

Page: 128 / 152

120
MAINTENANCE AND INSPECTION
5.1 Maintenance and Inspection
5.1.5 Printer (NKG-52) Maintenance and Inspection
Inspection sequence Inspected item Procedure
1 Printer control system Check the printer cable connection.
2 Print out test (see *1) Perform a print out test using the JHS-32B.
3
FEED
switch Press
FEED
and check that paper advances by one
line.
4 Alarm operation Open the paper cover, remove the paper roll from
the holders, then press
FEED
. Check that the
buzzer sounds (because the printer is now out of
paper).
5
ALM OFF
switch (see *2) If the buzzer sounded in item 4, press the
ALM OFF
switch to stop the alarm.
6
RESET
switch After stopping the alarm (item 5), press the
FEED
switch. It should not function (because the printer is
in the error state) . Check that the paper advances by
one line when RESET is pressed. Then press
FEED
and check that the paper advances by one line.
TIP
• *1 Perform the print test using the main unit
(JHS-32B).
• *2 When an alarm sounds, replace the printer
paper. Replacing the paper will not stop the
alarm.
• *3 Be sure to perform this test only after item 4.
This test can not be performed under any other
conditions.
(cancellation of error state)
(see *3)