14
3-1
SERVO INSTALLATION
RADIO INSTALLATION SUGGESTIONS
Be sure to install four rubber servo grommets and eyelets to
each servo prior to installation.
When adjusting control rods, be sure to adjust each universal
link the same amount so as not to unthread one link too far.
Be sure to keep all servo lead wires, etc., away from all servo
arms, rods, and sharp edges of the helicopter’s mechanics.
After final installation, group these wires together as indicated
using the small nylon wire ties and the nylon spiral tubing
included with this kit.
Note:
It is suggested that the switch harness be
installed prior to installation of the rudder servo.
Note:
Once the servos are installed, check to see if
the servos can be moved in the mounts. If the
servos can be moved slightly, tighten the servo
mounting screws until the servos remain in position.
2.6 mm Flat Washer (20)
2.6 mm Flat Washer (8)
Left Servo (C)
Front Servo (A)
2.6x12 mm Self-Tapping Screw (20)
2.6x10 mm Self-Tapping Screw (8)
Right Servo (B)
Throttle Servo
2.6 mm Flat Washer (12)
2.6x12 mm Self-Tapping Screw (12)
Rudder Servo
Route Servo B and C wires
through this hole.
