57
1. With the system installed in the sailplane, insert the bind
plug in the bind receptacle.
2. Turn on the receiver switch. Note that the LED’s on all
receivers should be flashing indicating that the receiver is
ready to bind.
3. Establish the desired fail-safe stick positions: normally
aileron, elevator, flaps and rudder at neutral (motor off if
equipped) .
4. Remove the bind plug. This will cause the system to go into
preset failsafe such that if signal is lost all channels will
acquire their preset failsafe positions.
Note
: Preset failsafe is only available on 9 - channel and
greater receivers.
5. Press and hold the bind button on the back of the
transmitter while turning on the power switch. Within a
few seconds the system should connect. The LED’s on
the receivers should go solid, indicating the system has
connected.
6. Remove the bind plug and store it in a convenient place.
7. After you’ve programmed your sailplane, it’s important
to rebind the system so the true neutral control surface
positions are programmed.
To enter the Function list, turn on the transmitter and then press
the LIST button on the transmitter. The following screen will
appear.
1. In Function List screen use the roller to highlight 11. REV.
SW and press the roller to access the Reverse switch
screen.
2. Rotate the roller to highlight the desired channel that you
wish to reverse and press the roller to reverse that channel.
3. Repeat this for all channels. Press the LIST button to return
to the Function Mode screen.
Step 10. Binding
Step 11. Entering Function List
Step 12. Servo Reversing
