2
3
XS3 PRO Quick Start Setup
Synthesized RX Channel Select
1.
Determine the frequency band and channels available
marked next to the rotary dial matches the transmitter.
2.
Set the channel on the RS310 receiver to match the
XS3 PRO transmitter by adjusting the ten position
rotary switches using the supplied tuning screwdriver
until they point to the corresponding channel
numbers.
• To set a 75MHz receiver to channel 78, rotate the
first rotary switch to the “7” position and the second
rotary switch to the “8” position.
• 27Mhz receivers will only have one rotary switch for
accessing the channels 1–6. Use this single switch
to select the desired channel.
Servo Reversing
1.
With the transmitter power switch on, press the
Scroll
key to enter the Function mode.
2.
Press the
Scroll
key until “REV.NORM” appears on
the screen. The “ST” indicates the steering servo
reversing screen.
3.
Press the
Increase
or
Decrease
key to move the
cursor to the desired servo direction (REV.NORM).
4.
Press the
Channel
key once to access the throttle
servo reversing screen.
5.
To select the direction of the throttle servo, repeat
Step 3 above.
6.
Repeat Steps 2 and 3 to adjust Auxiliary Channel 3
if needed.
SCROLL
INCREASE
CLEAR
DECREASE
Included in this manual are in-depth instructions detailing
all the steps and procedures needed to correctly program
each of the XS3 PRO’s features. Quick Start covers the
basic programming information necessary to get you to
the track fast. Later, when you want to learn more about the
specific features of the XS3 PRO, refer to the appropriate
page(s) in this manual for more detailed programming
information.
Note
: If the Auxiliary Channel 3 is required, refer
to the Auxiliary Channel 3 System Mode (page 18)
for instructions.
Synthesized TX Channel Select
1.
Press the
Scroll
and
Channel
keys at the same time
and hold.
2.
Turn the transmitter power switch on to enter
System mode.
3.
Press the
Scroll
key until “CH” appears on the screen.
4.
Press the
Increase
or
Decrease
key to select the
desired transmitting channel number (1–6) on 27MHz
or (61–90) on 75MHz.
Note
: Your XS3 PRO radio system will only operate
either on 27MHz or 75MHz, depending on the model
purchased, not both. While in System mode, there
is no RF output being generated by the XS3 PRO,
enabling you to safely make the appropriate channel
selection. You must turn the transmitter off and then
back on to enable RF output.
Channel Number
ch
65
Channel Select
Fuction
st
—
R E V • N O R M
Channel
ST = Steering
TH = Throttle
AUX = Auxiliary Channel 3
(optional)
Servo Direction
SCROLL
ENTER
CHANNEL
INCREASE
CLEAR
DECREASE
INCREASE
CLEAR
DECREASE
SCROLL
ENTER
CHANNEL
SCROLL
SCROLL
CHANNEL
