JPS RTU-292C, Installation And Operation Manual

Page: 29 / 100

RTU-292C Operations Manual
2-11
explanation of the Voice Prompt feature operation, and Section 6.2for field installation. The
factory default setting: disabled if the Voice Prompt Option is not installed and enabled if it is.
Table 2-12 Voice Prompts Enable
SW1-6 Voice Prompts
Off Disabled
On Enabled
2.8.14 LOCAL PHONE / LOCAL PHONE RING-THROUGH
Dipswitch SW1-7 enables or disables the RTU-292C Local Phone Option (no longer available).
This feature should be enabled only if the Local Phone Option is installed. The factory setting
is: Disabled (SW1-7 Off) if the Local Phone Option is not installed and enabled (SW1-7 On) if
it is. See Section 3.7 for an explanation of Local Phone Option operation.
SW1-8 enables the Local Phone Ring-Through feature. This causes the local phone to ring
whenever a call is received by the RTU-292C via the PSTN input. When disabled, the local
phone may still be used to send and receive calls, but will not ring when a call is received. Set
SW1-8 to On to enable Local Phone Ring-Through, and Off to disable this feature. This switch
should always be set to Off (disabled) when the Local Phone Option is not installed. The factory
setting is On (enabled) when the Local Phone Option is installed and Off (disabled) otherwise.
Table 2-13 Local Phone Enable
SW1-7 Local Phone
Off Disabled
On Enabled
Table 2-14 Local Phone Ringthrough
SW1-8 Ringthrough
Off Disabled *
On Enabled
NOTE: Local Phone Option no longer available from JPS