INSTRUCTION MANUAL
CODE 80328 REV A
21/2021 Page: 22
J
.P. SELECTA s.a.u.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
Tel 34 937 700 877 Fax 34 937 702 362
e-mail: [email protected] - website: http://www.grupo-selecta.com
Machine
SAFETY ZONE
Leave a free space of 30cm around the centrifuge.
With the centrifuge operating:
• Do not place hazardous substances in the safety zone.
• Personnel must be outside the safety zone.
Do not use the centrifuge:
If the speed reading (RPM) never reaches stabilization.
(in this case, actual speed could be very different from that indicated)
Contact with J.P. SELECTA’s technical service.
DO NOT INSTALL THE EQUIPMENT IN EXPLOSIVE ATMOSPHERES OR
WHERE SOLVENTS, OR OTHER PRODUCTS THAT MAY FORM EXPLOSIVE
OR FLAMMABLE MIXTURES, ARE USED OR STORED.
6 Installation
6.1 Transport
The centrifuge comes with four lifting supports, for positioning the unit.
Note that the unit weights 429 Kg.
6.2 Location
Place the centrifuge on an horizontal flat and stable surface.
The surface must allow adherence of the centrifuge legs.
This equipment can cause vibrations affecting other nearby equipments.
Extreme conditions of temperature, humidity and contamination could
negatively affect the machine security. Avoid direct exhibition to sunlight.
For normal operation, ambient working temperature should be between
10ºC and 40ºC, with a maximum humidity level of 80%.
Do not install the centrifuge in areas where flammable liquids are stored
or special protection areas.
Leave a free space of 30 cm around the centrifuge to permit refrigeration
of the equipment. This area is called
SAFETY ZONE
WARNING !
The installation instructions indicated in this manual
must be applied to guarantee the machine safety.
