To do cursor measurement, follow these steps:
1.
Press F1 to open the cursor measurement;
2.
Press F2 to select a type of cursor measurement.
3.
Press F3 to select the channel that needs to be measured.
4.
Press F4 to enter the second page, press F1 or F2 to select Cursor1 or Cursor2, press
up, down, left and right to move Cursor1 or Cursor1;
5.
The result of cursor measurement will be displayed on the cursor menu.
Automatic Measurement
The oscilloscope provides 2 kinds of automatic measurements, including frequency
and amplitude.
Press
Menu
button to enter, select
Measure
to enter automatic measurement. Press
F1
to open, the measurement results will be displayed in the top left corner of the
screen.
Attention
:
In the measurement result, the yellow font is the result of CH1, and the green font is
the result of CH2.
•
Utility
Press Menu Button to enter.
Menu
Description
Frequency
Measure the frequency of the signal
.
Maximum
Voltage
Measure the maximum voltage of the signal
.
Minimum Voltage
Measure the minimum voltage of the signal
.
Menu
Setting
Description
Language
German
English
French
Set the menu language
.
Sound
On
Off
Open the key sound
.
Close the key sound
.
Backlight
luminance
1~10
Set backlight brightness of the screen.
Backlight
time
30s
60s
90s
120s
Unlimited
Set the screen backlight time
.
System
infor-
mation
Display system information, such as software version or
PCB version.
Automatic
shutdown
5 Minute
10 Minute
20 Minute
30 Minute
Unlimited
Set automatic shutdown time
.
Calibration
Start
Return
Start the self calibration
.
Exit the self calibration
.
