26
139472_Rev_B 8.28.12
Maintenance
This appliance and venting system should be inspected
before use and at least annually by a qualified service
technician
General cleaning:
Vacuum the controls area under the firebox at least
monthly or more frequently if pet hair is in the
environment.
The firebox should be vacuumed annually. Be sure
to vacuum or wipe off the pilot assembly and burner
orifice and burner tube. Use a brush attachment to
vacuum the log set.
Inspect the pilot assembly for signs of corrosion and
replace any suspect components.
Gasket inspection:
Inspect the glass gasket annually.
Examine the gasket for signs of deterioration or
stiffness and confirm that the gasket maintains
a positive seal. This is important to prevent
combustion gases escaping into the room. Replace
the gasket if necessary. Refer to the replacement
parts list on page 28.
Accent Lamp Replacement
1. Remove the cast iron Upper Grill
2. Remove the lamp shade and bulb receptacle (three
screws). See fig. 42, pg. 28. Replace with 222943 130V,
50W light bulb.
3. Handle the new bulb with gloves. Skin oils will cause
the bulb to fail prematurely. If you touch the bulb
with your bare skin, wipe it clean with a soft cloth.
4. Replace components previously removed.
Battery Replacement
The battery box is located in the controls compartment
to the left of the valve assembly. Simply disengage it
from the hook and loop tape within the battery heat
shield, taking care against pulling on the wire leads. See
items 22 and 24, fig. 39 on page 27.
Use four, AA batteries, noting the polarity indicated on
the box.
Glass Care
Moisture condensation is a normal occurrence with gas appli-
ances and particulate accumulation may appear on the inside
surface to the glass. Use a dampened, soft cloth to clean the
glass and polish with a dry, soft towel. Specially-formulated
ceramic glass cleaner may also be used.
CAUTION:
THE IGNITION SYSTEM OF THIS APPLIANCE CARRIES
LIVE VOLTAGE. ALWAYS TURN OFF THE GAS SUPPLY
TO THE INSERT AND DISCONNECT THE POWER
SOURCE BEFORE ANY SERVICE WORK IS PERFORMED,
INCLUDING BATTERY REPLACEMENT.
WARNING:
OBSERVE CAUTION NEAR THE GLASS. THE GLASS
PANEL MAY SHATTER IF STRUCK WITH AN OBJECT.
ALWAYS HANDLE THE GLASS PANEL WITH CARE.
REPLACEMENT OF THE GLASS SHOULD BE DONE BY A
LICENSED OR QUALIFIED SERVICE PERSON. USE ONLY
REPLACEMENT GLASS PROVIDED BY YOUR AUTHORIZED
SCAN DEALER.
Glass Replacement
To remove the glass panel or glass gasket:
1. Open the Controls Panel.
2. Use the Latch Tool to release the glass clips on either
side of the bottom of the firebox.
3. Swing the bottom of the glass frame out and lift up to
disengage it from the firebox.
4. Lay the assembly on a flat surface and use a flat blade
screwdriver or pliers to pry up the two steel tabs that
secure the glass panel to the frame.
5. Install the new glass panel and gasket in the glass
frame and secure with the steel tabs. Do not over
tighten the tabs as that could break the glass.
ALWAYS USE SCAN AUTHORIZED PARTS. NEVER SUBSTITUTE
ANY OTHER PARTS.
Figure 38. Glass Replacement. Bend tabs to secure panel.
Figure 37. Gasket application, PN 129124.
DO NOT USE ABRASIVE OR AMMONIA BASED CLEANING
SOLUTIONS. TAKE CARE NOT TO SCRATCH THE GLASS
SURFACE.
