23
139472_Rev_B 8.28.12
Figure 30. Surround engagement points.
Engage Surround Panel
tabs with these slots.
Figure 32. Open the Controls Access Panel and hang the
Front Assembly on the front of the surround brackets.
Figure 31. Both the standard 48” x 30” Backing Plate and
the 48” x 36” Trimmable Backing Plate hang off the back
of the surround brackets.
Trim excess 2” if
Riser Bar is not
used.
Figure 29. Adjusting the Leveling Brackets.
Standard or
Trimmable
Backing Plate
Front
Assembly
Riser Bar
Leveling
Brackets
Standard Ventilated Control Door
Optional Full-Panel Control Door
NOTE:
THE OPTIONAL FULL-PANEL CONTROL DOOR MAY
ONLY BE USED IN CONJUNCTION WITH THE RISER
BAR. THE INSERT FIREBOX MUST BE RAISED 2
INCHES OFF THE FIREPLACE FLOOR AND THE RISER
BAR INSTALLED WITH THE SURROUND PANEL.
WARNING!
USE OF THE FULL-PANEL CONTROL DOOR WITHOUT
THE RISER BAR WILL VOID THE WARRANTY AND
MAY RESULT IN DAMAGE TO THE APPLIANCE, RISK
OF FIRE, PERSONAL INJURY, OR LOSS OF LIFE.
Install the optional full-panel control door using
the same fasteners and magnets as the ventilated
control door.
Control Doors
