jotron RA-7203C, Operator'S Manual, Page: 25 / 88

Jotron AS| TR7750C: Operators Manual

Functional description Page 3-12
P/N: 84748 (G)
3.4.5 AUX2 connector (RJ45)
This connector is normally connected to equipment used for remote control / remote supervision of
the transmitter.
AUX2 connector, receiver unit
Name
PIN Purpose
Squelch_out_P 1 Closed=Receiving (Sq open), optocoupler output
Squelch_out_N 2 Closed=Receiving (Sq open), optocoupler output
AGC_HILO_P 3 Hi/Lo output depending on signal strength,
optocoupler output
N/C 4
N/C 5
AGC_HILO_N 6 Hi/Lo output depending on signal strength
AGC_OUT 7 AGC analogue voltage output, depending on signal
strength. Referred to GND
N/C 8
Table 3.4-3, AUX2 connector, receiver, pin out
3.4.6 REM connector (RJ45)
This connector is normally connected to a mating transmitter unit (RX connector) when used in a
transceiver configuration, or to other equipment used for remote control of the receiver.
When connected to a transmitter, the connector gives “transceiver” functionality to the transmitter
and contains necessary signals for audio and control. The TX_BUSY and RX_BUSY signals are also used
in data modes to signal that the transmitter or receiver is busy transferring data.
Interface to Remote equipment or a transmitter unit
Name
PIN Purpose
RS485+ 1 RS485 (+)
RS485- 2 RS485(-)
LINE_P 3 Line output from Receiver unit, 600 ohm
TX_BUSY 4 TX Busy indicator input (Mute input)
RX_BUSY 5 RX Busy output
LINE_N 6 Line output from Receiver unit, 600 ohm
INT_ALARM 7 Low=Alarm (Note: I/O – low input will also be
recognized as an alarm (EXT))
GND 8 Common ground
Table 3.4-4, REM connector, receiver, pin out
5
6
7
8
9