2
INTRODUCTION
Jordan Controls, Inc., designs, manufactures, and tests
its products to meet national and international stan-
dards. For these products to operate within their
normal specifications, they must be properly installed
and maintained. The following instructions must be
followed and integrated with your safety program
when installing, using, and maintaining Jordan Controls
products:
Read and save all instructions prior to installing,
operating, and servicing this product.
If any of the instructions are not understood, contact
your Jordan Controls representative for clarification.
Follow all warnings, cautions, and instructions marked
on, and supplied with, the product.
Inform and educate personnel in the proper installa-
tion, operation, and maintenance of the product.
Install equipment as specified in Jordan Controls
installation instructions and per applicable local and
national codes. Connect all products to the proper
electrical sources.
To ensure proper performance, use qualified personnel
to install, operate, update, tune, and maintain the
product.
When replacement parts are required, ensure that the
qualified service technician uses replacement parts
specified by Jordan Controls. Substitutions may result
in fire, electrical shock, other hazards, or improper
equipment operation.
Keep all actuator protective covers in place (except
when installing, or when maintenance is being per-
formed by qualified personnel), to prevent electrical
shock, personal injury, or damage to the actuator.
WARNING
Before installing the actuator, make sure that it is
suitable for the intended application. If you are unsure
of the suitability of this equipment for your installation,
consult Jordan Controls prior to proceeding.
WARNING - SHOCK HAZARD
Installation and servicing must be performed only
by qualified personnel.
WARNING - ELECTROSTATIC DISCHARGE
This electronic control is static-sensitive. To
protect the internal components from damage
caused by static discharge, never touch the printed
circuit cards without being statically protected.
RECEIVING INSPECTION
Carefully inspect for shipping damage. Damage to the
shipping carton is usually a good indication that it has
received rough handling. Report all damage immedi-
ately to the freight carrier and Jordan Controls, Inc.
Verify that the items on the packing list or bill of lading
agree with your own.
STORAGE
If the actuator will not be installed immediately, it
should be stored indoors in a clean, dry area where
the ambient temperature is not less than -20° F. The
actuator should be stored in a non-corrosive environ-
ment. The actuator is not sealed to NEMA 4 until the
conduit entries are properly connected.
EQUIPMENT RETURN
A Returned Goods authorization (RG) number is
required to return any equipment for repair
. This
must be obtained from Jordan Controls. (Telephone:
414/461-9200) The equipment must be shipped,
freight prepaid, to the following address after the RG
number is issued:
Jordan Controls, Inc.
5607 West Douglas Avenue
Milwaukee, Wisconsin 53218
Attn: Service Department
To facilitate quick return and handling of your equip-
ment, include:
RG Number on outside of box
Your Company Name, Contact Person, Phone/Fax #
Address
Repair Purchase Order Number
Brief description of the problem
GENERAL INFORMATION
Summary of Contents for SM-1715
Page 23: ...23...
