Room Instruction Manual
Page 8
To Fold and Pack the Playard
• Before folding the playard be sure to remove all accessories from the playard including the bassinet,
changing table, parent organizer, MP3 or any other attachments. Unplug the MP3 cord and store in pocket.
• To fold the playard, detach the Velcro® straps at the corners of the mattress from the underside of the floor
and guide each of the straps through the slots in the floor to release. See Figure 10.
• Lift the mattress from the playard and set it aside. If necessary, remove the mattress sheet.
• Pull upward on the webbing loop near the center of the playard floor. Be sure that the center of the floor is
pulled up all the way. See Figure 11.
• With the center of the floor pulled up, locate the button at the center of one of the top rails.
NOTE: The button is sewn inside the fabric near the center of each top rail.
• Pull upward on the top rail and squeeze the button. Then push down until the locking mechanism is
released on BOTH sides of the top rail. See Figure 12.
NOTE: If the rail tubes do not unlock, do not force them. Lift the center of the floor higher and try again.
• Once you have successfully released BOTH tubes and folded that top rail, repeat this procedure on the
other top rails until all four top rails have been folded.
• Gather the playard together until it is compact and completely folded. See Figure 13.
NOTE: DO NOT force the playard. If the unit will not fold, look for a partially latched top rail and squeeze
the button in to release the rail.
• Lay the mattress on the floor with the soft side facing up. Lay the folded playard frame on the mattress,
fold the mattress around the frame with the short section tucked in. See Figures 14 and 15.
• Locate the Velcro® straps on the end of the mattress, thread them through the plastic rings on the other
side of the mattress and attach them. See Figure 16. Then stand the playard upright.
NOTE: There are three straps; one near the top, one near the center and one near the bottom.
• Open the zipper on the large section of the travel bag and slide the bag over the folded playard with the
handle on the outside of the playard mattress facing the opening of the bag. See Figure 17. Once the
playard is completely inside the travel bag, close the zipper. When inserted properly, the handle should be
accessible through the opening in the bag.
NOTE: The bassinet, changing table and the components for each can be stored in the small section of
the travel bag. The parent organizer is not intended to be stored inside the travel bag
.