Jonix duct 70MIC2C, Use And Maintenance Manual

Page: 24 / 32

24
JO NIX
duct
In the event that you experience a malfunction other than those described above
contact qualified staff (retailer, Manufacturer).
This section summarises the most common problems that may arise when using the unit. Before
contacting customer services, carry out the checks listed below.
8 - OPERATIONAL CHECK AND TROUBLESHOOTING
Unplug the device from the mains and contact qualified staff for assistance even in the event of
one or several of the cases below:
• The power cable is damaged or worn.
• The plug is damaged or worn.
• Water or liquid has been poured onto the device.
• In the event that there is a malfunction despite all the installation procedures have been carried
out properly.
PROBLEM
POSSIBLE
CAUSE
SOLUTION
The switch does not light up when set at I.
The unit is not
powered.
Check that the plug is connected to the
mains power socket.
Verify that the plug is connected to
thepower supply socket on the module.
Verify that the socket where the device is
connected works.
Verify the presence of power in distribution
system.
Verify that the protection fuse isn't burnt.
The alarm contact 1 notes the presence of a
malfunctioning and the spy is on. The red led of the
internal electronic card emits an intermittent flashing.
The system
detects the need
of cleaning the
ionising tube.
Follow the cleaning of the ionising tubes
procedure in paragraph afo 7.2.1.
The alarm contact 1 notes the precence of a
malfunctioning and the spy is on. The red led of the
internal electronic card emits two intermittent flashing.
The system
detects the need
of replacing the
ionising tube.
Follow the replacement of the ionising tubes
procedure in paragraph 7.3.1.
The alarm contact 2 notes the precence of a
malfunctioning and the spy is on. The red led of
the internal electronic card emits four intermittent
flashing. The system
detects the need
of replacing the
ionising tube.
Follow the replacement of the ionising tubes
procedure in paragraph 7.3.1.
Power supply present, no malfunction, but the
ionization is not active.
Ionization
activation
contact open.
Check that the ionization activation contact
is normally closed.