JollyLine JL43700, User Manual

Page: 34 / 59

5
ENGLISH
Technical specification
DVB-T2 Tuner Frequency range 177.5-226.5MHz 474-858MHz
Band 7MHz/8MHz
Input impedance 75 Ω
Channel decoding Standard DVB-T/T2 main 10 bit HEVC, FTA
Video decoding Standard MPEG-2MP@ML (up to 1080p@60fps)
MPEG-4 ASP@L5HD (up to
1080p@60fps)
MHEG-5 (up to 1080p@60fps)
Aspect ratio 16:9 4:3
Video format PAL
Video resolution 576i / 576p / 720p / 1080i/1080p
Audio decoding Decoding MPEG-1 Layer I/II, MPEG-2 layer I/II,
MHEG-5
AAC, AAC+/HE-AAC/AC3/E-AC-3/DTS
Output mode Mono/Joint Stereo/Stereo
Sampling frequency 32, 44.1 & 48 kHz
Power data Input voltage 100-240V~ 50/60Hz
Power 2.6W
Standby consuption 0.72 W
Operative condition Working temperature Da +5 ℃ a 55 ℃
Installing remote control batteries
Remote control works with 2 AAA batteries (1.5V). On the rear of the remote control there is the batteries
compartment. To open it, push slightly the upper part of the window (identified by a knurling) and slide the
lid.
Place the batteries following the right polarity, indicated on the bottom of the compartment. Close the lid,
sliding until the end. Use only batteries of the specified size and voltage.
If the remote control is not used for a long time, remove the batteries. Do not leave dead batteries in the
remote control.
If liquid is produced from the batteries, wipe it off with a cloth and replace the batteries.
Do not throw batteries into fire, do not short-circuit them, do not open them or subject them to excessive
temperature.
Batteries are not rechargeable, do not attempt to recharge them.
Replace the batteries with others of the same type. Do not use a new and an old battery or batteries of a
different type, replace both with new identical ones.
Do not disperse batteries in the environment.
Using the remote control
The remote control must be directed towards the front of the appliance, where the IR sensor is. Remove
any object that may influence the trajectory from the remote control to the sensor. Exposure to strong
sunlight could affect the sensitivity of the remote control.