Jolly Mec UNIVERSAL JOLLY Maxi, Installation, Use And Maintenance Card, Page: 10 / 24

8
1.6 Fireplace operation
8
1.6.3 Advice
Use only original spare parts recommended by the manufacturer.
Original spare parts are available through retailers, specialised
Tecnical Service Centers, or directly at the head office of Jolly
Mec Caminetti S.p.A.
Regular and methodical maintenance is all-important for correct
operation and maximum efficiency.
This is a high performing fireplace which works with a closed
door concept. If the doors are opened and the flue draught is
not optimal (12 Pa), small puffs of smoke may occasionally
occur.
If, for example, it is necessary to open the doors to load some
wood, check that you have opened the fume damper as far as
possible to prevent the formation of small puffs of smoke. When
you have finished and reclosed the doors, reset the damper to
its standard operating position.
WARNING!
In case of a power failure, if the fireplace is lit and
loaded with lots of wood, some electrical components
could become damaged.
In case of a power failure, check the heat output of the
fire and if high, remove a few pieces of wood to reduce
it.
ATTENZIONE!
The firebox must always be closed, except when
loading fuel, to prevent smoke escaping. For models
with two doors, always open (slowly) the right door
first and then the left one.
The only part not covered by
cladding and therefore subject to high temperatures
is the glass.
THE fan must be activated with the fireplace lit, as the
”UNIVERSALJOLLY” is a very powerful heat exchanger fireplace.
F
ig
. 1
Damper in standard position (optimum fireplace efficiency)
F
ig
. 3
Damper shifted forward to further increase draught
MORE CLEANING = MORE EFFICIENCY
The fireplace can be used in summer to ventilate the rooms, by
setting the controller to SUMMER and adjusting the fan speed.
If the flue draught is insufficient and smoke escapes at the
doors, the draught can be adjusted by means of the damper
which can be positioned in order to facilitate the rear passage
of fumes. ( F
ig
. 2-3 ).
If a decrease in draught is noticed, remove the damper
and clean any soot fallen from the flue onto the boiler.
If a decrease in hot air is noticed, this means that the fan needs
cleaning: access it by removing the fire bed; See par. 1.7.2
F
ig
. 2
Damper shifted forward to increase draught