Jolimark BP-1000K (Model B), User Manual

Page: 28 / 44

BP-1000K User’s Manual
4.5 TOF Adjustment
TOF is mean top of form position. When paper is loaded, the printer detects the
end of the paper and determines the printing start position based on the
detected paper end. That position is the top of the form. When the printer online,
Top of Form
adjusting…
(default)
press ▲ LF/FF for 3 seconds, and the printer LEDs of the power and online on
the control panel blink by turns. The LCD display as right figure show. That is
mean the printer is in the mode of TOF adjustment.
Press “ ▲ ”, “ ▼ ” can change the setting of TOF (the max dimension of the changing of TOF is measure
by the default setting under zero position):
“
▲ ” Press one time go forward 1/60 inch, max is 60/60 inch.
“ ▼ ” Press one time go backward 1/60 inch, max is 30/60 inch.
After adjustment, press “ ► II ”, the power light and the online light blink 3 times, and make out 2 times of
“beep”. Now the setting of TOF has been saved and exit.
4.6 Tear Position Adjustment
“Tear position adjustment” mainly use to adjust the distance between the connect
slot and the upper cover which make you more easily to tear the continuous paper.
In the state of online, press
▲ Load/Eject and ▼ LF/FF at the same time for 3
seconds, then can enter the mode of tear position adjustment. Here, the online
light and the power light blink by turns, the LCD display as right picture show.
(default)
Tear-off pos.
adjusting…
You can adjust the tear position by pressing “ ▲ ”and“ ▼ ”, (the max dimension of the changing of tear
position is measure by the default setting under zero position):
“
▲ ” Press one time go forward 1/60 inch, max is 15/60 inch.
“ ▼ ” Press one time go backward 1/60 inch, max is 15/60 inch.
After adjustment, press “ ► II ”, the power light and the online light blink 3 times at the same time, and
make out 2 times of “beep”. Now the setting of tear position adjustment has been saved and exit.
4.7 The Self Test Functions
4.7.1 ASCII Self-Test
Press Online then turn on the power of the printer. The printer would print out a piece of ASCII
pattern and then exit ASCII self test mode. Now you can start printing.
If you press
Online and Load / Eject at the same time then turn on the printer, it will print out the
ASCII pattern continuously. Press Online can pause it. If you want to exit now, you can turn off the
power then turn on again.
Version: BP-1000K v XXX 20XX/XX/XX
!"#$%&’( )*+-./0123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`abc
!"#$%&'( )*+-./0123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`abcd
"#$%&'( )*+-./0123456789:;<=>?@ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_`abcde
ASCII SELF TEST MODE
Figure 4-3 ASCII self test mode
4.7.2 Chinese Self Test Mode
Press LF / FF then turn on the power of the printer. The printer would print out Chinese pattern.
Press Online can pause it. If you want to exit now, you can turn off the power then turn on again.
- 24 -