BP-1000K
User’s Manual
29
BAUD RATE
Set the printer RS-232C interface speed.
30
PARITY
Set the printer RS-232C interface parity error checking type.
31
DATA BIT
Set the printers RS-232C data width either 8 bits or 7 bits.
32
STOP BIT
Set the printers RS-232C transmission stop bits.
33 PROTOCOL Set the printers RS-232C interface protocol is software (XON/XOFF) or hardware
(DTR).
34
BREAK PIN
Select broken-pin mode.
35 PIN
SWITCH Select pin switch mode. The printer auto-switch the different pin to print table Line.
4.4.4 Online Aptitude Parameter Setting
This printer supports online aptitude parameter setting, you can set the printer parameter in PC
through using the Driver of this printer.
Setting method as follow:
1. Ensure the printer and the computer are connecting with interface cable. Turn on both the printer
and the computer, and the printer is in online state.
2. Click “Start”
→
“Setting”
→
“Printers and Faxes”, open a window of “Printers and Faxes”.
3. In the window of “Printers and Faxes”, select the Driver of this printer, right click it and click
“Property” in the choose column.
4. Then it show a window of “Property”, click “Printer setting”.
5. Corresponding with the third submenu setting methods of printer menu system, in the window of
“Printer setting”, select main menu in the “Setting type”, select second submenu in “Setting option”,
at last, select setting parameter in current parameter item.
6. Click the button of “Reset all the items as default settings” to resume all the parameter to driver
default setting and not change the printer parameter.
7. During setting parameter: You can click “Setting current item” to save the current item after setting
parameter each time. Also you can click” Setting all items” to save all the items after setting all
parameters. Click both “Setting current item” and “Setting all items”, the program will send the
parameter command to the printer.
8. The printer will change the parameter setting right after it receives the setting parameter command.
It doesn’t need to restart the printer.
9. After finish setting, click “OK” to exit “Property”.
4.4.5 Restoring Factory Printer Settings
You can restore to the factory printer settings without having to work through the Setup Menu
System to reset the menus.
To restore to the factory settings:
1. Make sure that the printer is
Online
.
2. Press and hold down the
Online
and
Copy
keys on the control panel for 3 seconds.
The LEDs of the
Power
and
Online
on the control panel blink 3 times at the same time and the
printer makes 2 times of “beep” to confirm that the printer’s factory settings have been restored.
4.4.6 Head Pin Test
Press
High speed
then turn on the power of the printer. The printer would print out a piece of “Head
pin test” pattern. Each pin prints a line. If certain pin cannot print its line, select broken-pin mode from
LCD menu.
- 23 -
Summary of Contents for BP-1000K (Model B)
Page 1: ...User s Manual BP 1000K Model B...
Page 20: ...BP 1000K User s Manual Figure 3 8 Tearing the tractor paper 16...
Page 44: ......
