25
JWS-3 Installation and Operation Manual - P/N: 53550:Rev: A1 1/12/10
Section 3 JWS-3 Configuration
3.1 Configuration PC Preparation
3.1.1 Connect the Configuration PC to the JWS-3
If your Configuration PC is on the same IP network you connected the JWS-3 to in the step,
“Connecting an JWS-3 to an IP Network” on page 20
, then your Configuration PC is already
connected to the JWS-3. Proceed to
“IP Network Configuration” on page 25
.
Otherwise, refer to
Appendix B.1, “Direct Connection to the Gateway PC Board”, on page 49
.
3.2 IP Network Configuration
Step 1. Once JWS-3 is powered and physically connected to the network, open a browser from a
PC on the same network, and browse to the default address:
192.168.1.2
This launches the JWS-3 interface.
Step 2. Log into JWS-3. Refer to
“Browser Security Settings” on page 27
Step 3. From the JWS-3, click the
Administration
tab, and then choose
System Settings
from
the list on the left.
a. Type in the IP address into the “IP address” field.
• A JWS-3 user will type this IP address into their browser to connect to the JWS-3.
• If the JWS-3 is to be used on the internet, you may need to independently set up a
router and/or fire-wall so the internet-based applications can locate and access the
JWS-3. Contact your appropriate MIS personnel for details.
b. Enter the Subnet Mask into the “Subnet Mask” field.
• This is the IP subnet mask the JWS-3 should use to determine whether a
connection came from a local network or should be routed on to another network.
• All of the IP settings for the JWS-3 must be on the same subnet for
communications to be established between the JWS-3 and a browser.
c. Type in the values into the “IP address for routing back to Internet” field.
• This sets the IP of a router that the JWS-3 can use to locate the browser with which
it is communicating.
• This sets a path for the JWS-3 to use to communicate back to the connecting
browser.
d. If applicable to your application, select an NCM Threshold and Network Styles.
• The NCM threshold can be set to high or low.
• The network style can be set to style 4 or style 7.
• Refer to the NCM documentation for more details on these fields.
Step 4. Refer to for information about configuring additional settings.
!
CAUTION: Multiple JWS-3 Installations
JWS-3s should be installed and configured one at a time because all JWS-3 use the same default IP
address and node number.
NOTE:
You must have completed the installation of the JWS-3 before you proceed with this
preparation (refer to
“JWS-3 Embedded Installation” on page 13
).
