Static Discharge Precautions
Static charges produce voltages high enough to damage
electronic components. The microprocessors and
associated circuitry within an FX30E/FX60E are sensitive
to static discharge.
Important:
Work in a static-free area. Discharge any
static electricity you may have accumulated.
Discharge static electricity by touching a
known, securely grounded object. Do not
handle the Printed Circuit Board (PCB)
without proper protection against static
discharge. Use a wrist strap when handling
PCBs. Secure the wrist strap clamp to earth
ground.
Accessories
The FX30E/FX60E has a 20-pin, right-angle, Euro-DIN
connector that accepts accessory modules. The
connector provides power and signal lines to any
connected modules. The connector is located on the end
of the FX30E/FX60E opposite the option cards.
Important:
Turn off power to the FX30E/FX60E before
inserting or unplugging accessory modules.
Wait for the LED activity to stop (all LEDs
off).
Risk of Property Damage.
Do not apply power to the
system before checking all wiring connections. Short
circuited or improperly connected wires may result in
permanent damage to the equipment.
MISE EN GARDE: Risque dégâts matériels.
Ne pas
mettre le système sous tension avant d'avoir vérifié tous
les raccords de câblage. Des fils formant un court-circuit
ou connectés de façon incorrecte risquent
d'endommager irrémédiablement l'équipement.
Each accessory module has a DIN-mount base, and
typically provides two 20-pin connectors that allow you
to chain multiple accessories (see DIN Rail Mounting
Instructions).
Table 1
lists the currently available modules.
Accessory Module Details
Table 1: Accessory Module Details
Notes
Description
Model
Install only one power module per
FX30E/FX60E, regardless of type
Power module for FX30E/FX60E
24 VAC/DC, DIN rail mountable
LP-FXPM24-0
Install only one power module per
FX30E/FX60E, regardless of type.
Power module for FX30E/FX60E
90-263 VAC, DIN rail mountable
LP-FXPM263-0
Provides the following I/O points:
•
8 universal inputs (UIs)
•
4 digital outputs (DOs), single-pole
single-throw (SPST) relay type
•
4 analog outputs (AOs) (0-10 VDC)
Up to four (maximum) NDIO16 accessory
modules are supported
16 channel input/output module for
FX30E/FX60E, DIN rail mountable
LP-FXNDIO16-0
Provides the following I/O points:
•
16 universal inputs (UIs)
•
10 digital outputs (DOs), SPST relay
type
•
8 analog outputs (AOs) (0-10 VDC)
One NDIO34 plus up to 2 additional
NDIO16 modules are supported. Do not
power the NDIO34 if using a separate wall
plug power module.
34 channel input/output module for
FX30E/FX60E, DIN rail mountable. In
addition, the NDIO34 provides power to
the attached FX30E/FX60E, using an
externally supplied 24 VAC transformer or
24 VDC power supply.
LP-FXNDIO34-0
3
FX30E/FX60E Supervisory Controllers Installation Instructions
