3. Hang the controller on the DIN rail by the hooks at
the top of the (DIN rail) channel on the back of the
controller (), and position the controller snugly against
the DIN rail.
4. Push the bottom mounting clips inward (up) to secure
the controller on the DIN rail.
To remove the controller from the DIN rail, pull the
bottom mounting clips out to the extended position
and carefully lift the controller off the DIN rail.
Wall Mount Applications
To mount a field controller directly on a wall or other flat
vertical surface:
1. Pull the two bottom mounting clips outward and
ensure they are locked in the extended position as
shown in .
2. Mark the mounting hole locations on the wall using
the dimensions in and one of the mount positions
shown in . Or hold the controller up to the wall or
surface in a proper mount position and mark the hole
locations through the mounting clips.
3. Drill holes in the wall or surface at the marked
locations, and insert appropriate wall anchors in the
holes (if necessary).
4. Hold the controller in place, and insert the screws
through the mounting clips and into the holes (or
anchors). Carefully tighten all of the screws.
Important:
Do not overtighten the mounting screws.
Overtightening the screws may damage
the mounting clips.
3
FEC26Field Equipment Controllers Installation Instructions
