Johnson Controls CICS015B21S, Engineering Manual

Page: 57 / 72

OPTIONAL PARTS
TC-18004-rev.2
3-23
6
Lead the connecting cable into the electrical box with other wires.
Attach the accessory insulation to the edge of side cover R in order to prevent a scratch by contacting
the connecting cable to the edge of side cover R.
7
Remove the electrical box cover. Connect the connecting cable to the terminals A and B at the terminal
block for controller as following figure. (There are no polarity between terminals A and B.)
5
Attach the IR receiver kit to the lower cover.
(1) Insert the IR receiver kit and the connecting cable to
the position for IR receiver kit.
(2) Lead the connecting cable through the hole for
connecting cable.
(3) Catch 3 hooks of IR receiver kit onto the square holes.
Pay attention to the direction of IR receiver kit when it
is attached.
NOTE:
Check whether the IR receiver
kit is securely fixed.
Hook
IR Receiver Kit
Hook
Service Hole
Hole for
Connecting Cable
IR Receiver Kit
Attaching Direction
for IR Receiver Kit
EMERGENCY
COOL HEAT
RUN FILTER DEF TIMER
Side Cover R
Insulation
Put the side cover R and the flange
at lower cover between insulations.
Connecting Cable for IR Receiver Kit
Side Cover R
Lower Cover
Lower Cover
Electrical Box
Terminal Block
for Controller
Connecting Cable for Receiver Kit
Printed Circuit Board (PCB1)
Mark Band “A”
Mark Band “B”