Johnson Controls CICS015B21S, Engineering Manual

Page: 44 / 72

OPTIONAL PARTS
3-10
TC-18004-rev.2
6
Insert the connecting cable into the electrical box with the auto louver motor cable.
Attach the accessory insulation to the edge of side cover R carefully in order to prevent the connecting
cable from scratching against the edge of side cover R.
7
Remove the electrical box cover. Connect the connecting cable to the connector CN10 (5 poles, red) on
PCB1 as in the following figure. The DIP switch setting is NOT required since the motion sensor kit is
automatically recognized when the power supply is turned ON.
5
Attach the motion sensor kit on the lower cover.
(1) Insert the motion sensor kit and the connecting cable
to the position for the motion sensor kit.
(2) Insert the connecting cable through the hole for
connecting cable between insulations.
(3) Catch two hooks of the motion sensor kit onto
the square holes.
Pay attention to the direction of the motion sensor kit
when it is attached.
NOTE:
Check whether the motion
sensor kit is securely fixed.
NOTE:
After running the connecting
cable, clamp the extra length
of the connecting cable using
the cable band and store it
inside the electrical box.
After the installation work is completed, perform a test run according to the “Installation and Maintenance
Manual” for the indoor unit.
Side Cover R
Insulation
Put the side cover R and the flange
at lower cover between insulations.
Connecting Cable for Motion Sensor Kit
Side Cover R
Lower Cover
Lower Cover
Auto Louver Motor Cable
Electrical Box
Connecting Cable
for Motion Sensor Kit
Printed Circuit Board (PCB1)
Connector CN10
Red (5 Poles )
%0
Motion Sensor Kit
Attaching Direction
for Motion Sensor Kit
Lower Cover
Hook
Motion Sensor Kit
Service Hole
Hole for Connecting Cable
Insert it through this hole.