Johnson Controls CIC1006B21S, Engineering Manual

Page: 39 / 50

OPTIONAL PARTS
TC-18002
3-11
4
Follow the procedures from (1) to (3) to attach the IR receiver kit on the decorative panel..
5
Install the decorative panel to the indoor unit according to the “Installation and Maintenance Manual” for
the decorative panel.
6
Secure the IR receiver kit cable with the cable clamp of the indoor unit.
7
Remove the electric box cover of the indoor
unit. Connect the IR receiver kit cable to the
terminal blocks (A, B) in the electric box as
shown at the right. (Terminals A and B have
no polarity.)
● Pay particular attention to the installation direction of the IR receiver kit. Number of coupling hooks of
the IR receiver should match the notches at the installation position.
● Check to ensure that the IR receiver kit is securely installed.
● Be sure to attach the cable clamp (accessory) according to the required position.
If not, condensation may occur because of a space between decorative panel and the indoor unit.
Decorative Panel
Cable Clamp (Accessory)
Attaching Position
(1) Insert the IR receiver kit and cable into the attachment position.
Attach the coupling hooks (three portions) of the IR receiver kit
and the notches at the attachment positions securely.
(3) Pull out the IR receiver kit cable
through the hole of the decorative panel.
IR Receiver Kit Cable
(2) Attach the cable clamp (accessory) at the rear side
of the decorative panel to secure the IR receiver kit cable.
8 (203)
12 (304)
Unit: inch (mm)
Cable Through-Out Hole at
Optional Decorative Panel
Decorative Panel
Insert the IR receiver kit cable into
the cable clip at the indoor unit side,
and secure it. (three places)
IR Receiver Kit Electric Box
IR Receiver Kit Cable
Cable Clamp (Accessory) (three places)
Terminal Block
PCB
Electric Box
IR Receiver Kit Cable
Mark Band “A”
Mark Band “B”