John Lewis JLDWW 906, Instruction Manual

Page: 13 / 36

Setting the water
softener
The water softener must be set in two ways:
manually, using the water hardness dial and
electronically.
Setting manually
The dishwasher is factory set at
position 2.
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn the water hardness dial to position
1 or 2 (see table above).
4. Replace the lower basket.
Setting electronically
The dishwasher is factory set at level
5.
1. Press the On/Off button. The
dishwasher must be in setting mode.
2. Simultaneously press and hold function
buttons B and C , until the lights Glass ,
Rinse hold and Multi tab start
flashing.
3. Press function button A , the lights of
function buttons Rinse hold and Multi
tab turn off while the light of function
button Glass continues to flash. The
current level shows on the digital display.
Examples:
displayed = level 5
displayed = level 10
4. To change the level, press function
button A . Each time the button is
pressed the level changes. (For the
selection of the new level see the chart).
Examples:
If the current level is 5, by pressing
function button
A once, level 6 is
selected,
if the current level is 10, by pressing
function button
A once, level 1 is
selected.
5. To memorise the operation, switch off
the dishwasher by pressing the On/Off
button.
Filling with dishwasher
salt
Warning! Only use salt specifically
designed for use in dishwashers. All
other types of salt not specifically
designed for use in a dishwasher,
especially table salt, will damage the
water softener. Only fill with salt just
before starting one of the complete
washing programmes. This will
prevent any grains of salt or salty
water, which may have been spilt,
remaining on the bottom of the
machine for any period of time,
which may cause corrosion.
To fill:
1. Open the door, remove the lower
basket and unscrew the cap of the salt
container by turning it anticlockwise.
13