Water connections
Water inlet connection
This appliance must be connected to a cold
water supply.
For making the connection itself, the
coupling nut fitted to the machine’s inlet
hose is designed to screw onto a 3/4" gas
thread spout or to a purpose made quick-
coupling tap such as the Press-block.
The water pressure must be within the limits
given in the "Technical data". Your local
Water Authority will advise you on the
average mains pressure in your area.
The water inlet hose must not be kinked,
crushed, or entangled when it is being
connected.
The appliance features inlet and drain hoses
which can be turned either to the left or the
right to suit the installation by means of the
locknut.
The locknut must be correctly
fitted to avoid water leaks.
NOT all models of dishwashers have
inlet and drain hoses provided with a
locknut.
If the appliance is connected to new pipes or
pipes which have not been used for a long
time, you should run the water for a few
minutes before connecting the inlet hose.
DO NOT use connection hoses which
have previously been used on an old
appliance.
This appliance has been fitted with
safety features which will prevent the
water used in the appliance from
returning back into the drinking water
system. This appliance complies with
the applicable plumbing regulations.
Water drain connection
The end of the drain hose can be connected
in the following ways:
1. To the sink outlet spigot, securing it to
the underside of the work surface. This
will prevent waste water from the sink
running into the machine.
2. To a stand pipe provided with venthole,
minimum internal diameter 4 cm.
max 85 cm
min 40 cm
max 400 cm
The drain hose can face either to the right
or left of the dishwasher.
Ensure the drain hose is not bent or
squashed as this could prevent or slow
down the discharge of water.
The sink plug must not be in place when the
machine is draining as this could cause the
water to syphon back into the machine.
If you use a drain hose extension its internal
diameter must be no smaller than the
diameter of the hose provided.
Likewise the internal diameter of the
couplings used for connections to the waste
outlet must be no smaller than the diameter
of the hose provided.
31
Summary of Contents for JLDWW 906
Page 1: ...JLDWW 906 Dishwasher Instruction manual ...
Page 35: ...35 ...
