Hoyer
®
HPL700 and HPL 700WSC
8
English
Figure 4
Step 7
Figure 5
Steps 8, 9
Step 7
7.
Attach the front and rear covers (Figures 4 and 5), using the screws provided.
8.
Remove the key ring fastener from the boom actuator mounting bracket. Remove the pin
(Figure 5).
9.
Carefully remove the orange tie from the lifter actuator that is attached to the mast (Figure 5).
10.
Align the upper end of the lifter actuator and boom actuator mounting bracket (Figure 6).
Insert the pin. Install the key ring fastener.
11.
To connect the spreader bar to the boom, see instructions on page 16.
12.
Plug the handset and actuator cables into the bottom of the controller. Refer to the figures on
page 10 or 11 for correct positions.
Figure 6
Step 10
Boom
Control
Leg Control
