16
WARNING
:
Never attach a wood
cutting or carving blade of any type to
this angle grinder. It is designed for
grinding metal only. Use for any other
purpose is not recommended and
creates a hazard which will result in
serious injury.
WARNING:
Never cover air vents.
They must always be open for proper
motor cooling.
ON/OFF SWITCH
To turn the switch ON, press the back of
the switch slider (3) into the body of the
tool. While pressing on the rear of the
slider, push it forward (1) until the front part
of the switch (2) engages the catch
(Fig. 8). When the swi
tch “snaps” into
position, the switch will remain ON and the
motor will continue running. To turn the
switch OFF, press the rear of the slider
into the angle grinder body. The switch will
“snap” to the OFF position.
ASSEMBLY AND OPERATION
WARNING:
Have you read “GENERAL SAFETY WARNINGS”, “POWER
TOOL SAFETY”, “SPECIFIC SAFETY RULES”, EXTENSION CORD SAFETY” and
“SYMBOLS” on pages 3, 4, 5, 6, 7, 8 & 9 of this Manual? If not, please do it now
before you operate this angle grinder. Your safety depends on it!
Every time you use the angle grinder you should verify the following:
1. Cord is not damaged
2. Grinding disc is correct for the type of material being ground
3. Grinding disc is in good condition and securely tightened onto the spindle
4. Proper eye and hearing and breathing protection are being worn.
Failure to adhere to these safety rules can greatly increase the chances of
injury.
!
!
!
