8
Check to make sure the power cord and
any extension cord are clear of the area to
be cut. Contact with ”live” wires could
shock the operator or cause a fire.
Hold tool by insulated gripping surfaces
when performing an operation where the
tool may contact hidden wiring or its own
cord. Contact with a “live” wire will make
exposed metal parts of the tool “live” and
shock the operator.
Always hold the grinder securely with two
hands while working and at all times when
it is running.
Never turn the grinder ON with the grinding
disc or any rotating parts touching the work
surface.
Never cover the air vents in the motor
housing with your hands while operating
the grinder.
WARNING:
Keep the extension
cord clear of the working area.
Position
the cord so it will not get caught on the
workpiece, tools or any other
obstructions
while you are working with the power tool.
Make sure any extension cord used with
this tool is in good condition. When using
an extension cord, be sure to use one of
heavy enough gauge to carry the current
the tool will draw. An undersized cord will
cause a drop in line voltage resulting in
loss of power and overheating.
The table below shows the correct size to
use according to cord length and
nameplate ampere rating. If in doubt, use
the next heavier gauge. The smaller the
gauge number the heavier the cord.
Be sure your extension cord is properly
wired and in good condition. Always
replace a damaged extension cord or have
it repaired by a qualified electrician before
using it. Protect your extension cord from
sharp objects, excessive heat and damp or
wet areas.
Use a separate electrical circuit for your
power tools. This circuit must not be less
than 14 gauge wire and should be
protected with either a 15 A time delayed
fuse or circuit breaker. Before connecting
the power tool to the power source, make
sure the switch is in the OFF position and
the power source is the same as indicated
on the nameplate. Running at lower
voltage will damage the motor.
!
EXTENSION CORD
SAFETY
SPECIFIC SAFETY RULES
MINIMUM GAUGE (AWG)
EXTENSION CORDS
(120 V use only)
Amperage
rating
Total length
More
than
Not
more
than
25'
(7.5 m)
50'
(15 m)
100'
(30 m)
150'
(45 m)
0
6
18
16
16
14
6
10
18
16
14
12
10
12
16
16
14
12
12
16
14
12
Not Applicable
