SECTION 6 - JLG CONTROL SYSTEM
3121774
6-11
Only Lithium Input
SOC
89
Indicates the charge level of the battery pack, 100% is the maximum, 0% is the minimum
V LITHIUM
40
Indicates the total voltage of the lithium pack. When the cells are not under charge or under discharge, it tends
to the nominal value that is around 40 Volt, it doesn't matter their charge status.
A BATTERY
0
Indicates the value of the current (Amp) measured by the LEM sensor. With sign "-" the current is going out
from the battery pack (discharge), if there is no sign, the current is going inside the pack (charge)
BMS STATE
1
Indicates the bms status
V MAX CELL
3317
Indicates the voltage at the lowest cell. When the cells are not under charge or under discharge, it tends to the
nominal value that is around 3,3 Volt
2
Indicates the number of the lowest cell
V MED CELL
3316
Indicates the average voltage of the cell. When the cells are not under charge or under discharge, it tends to the
nominal value that is around 3,3 Volt
V MIN CELL
3315
Indicates the voltage at the lowest cell. When the cells are not under charge or under discharge, it tends to the
nominal value that is around 3,3 Volt
12
Indicates the number of the lowest cell
BMS A CHG
25
Indicates the maximum current (Amp) that BMS requires to the battery charger (with lithium pack not fully
charge)
T MAX CELL
23
Indicates the highest temperature (°C) detected among the cells
2
Indicates the number of the temperature sensor with the highest temperature detected
T MED CELL
23
Indicates the average temperature (°C) detected among the cells
T MIN CELL
23
Indicates the lowest temperature (°C) detected among the cells
1
Indicates the number of the temperature sensor with the lowest temperature detected
T BMS
27
Indicates the temperature (°C) detected on the BMS
SOH
98
Indicates the state of health of the battery pack; it indicates how much the battery pack could perform
B CAPACITY
80
Indicates the remaining capacity (Ah)
R MAX CELL
1
Indicates the highest resistance (mOhm) of the cells
1
Indicates the number of the cell with the highest resistance
R MED CELL
1
Indicates the average resistance (mOhm) of the cells
R MIN CELL
1
Indicates the lowest resistance (mOhm) of the cells
1
Indicates the number of the cell with the lowest resistance
HOURS INV
27
It counts the working hours with engine running
RPM INV
0
Indicates the engine rpm read by the engine rpm sensor. At a certain rpm setting, the rpm read depends also
on the electric load
Go to
Discount-Equipment.com
to
order your
parts