SECTION 4 - BOOM & PLATFORM
31215031
4-27
Disassembly
1.
Remove capscrews (113) over end cap lock pins (109).
2.
Using a 1/8” (3.18mm) drill bit, drill a hole in center of
each lock pin approximately 3/16" (4.76mm) deep.
3.
Remove lock pins using an ”Easy Out” (Size #2 shown. If
pin will not come out, use 5/16" drill bit 1/2" (12.7mm)
deep to drill out entire pin.
NOTE:
If the pin will not come out with the ”Easy Out”, use 5/1 6 in.
drill bit to a depth of 1/2 in. (12.7 mm) to drill out the entire
pin. Do not drill deeper than 1/2 in. (12.7 mm).
4.
Remove end cap (4) using tools provided with Helac seal
kit.
5.
Using a metal bar or similar tool, unscrew end cap (4) by
turning it counterclockwise.
6.
Remove end cap (4) and set aside for later inspection.
Go to
Discount-Equipment.com
to
order your
parts
