Page 25
|
Fathom SA
-600W
SYSTEM CONNECTION DIAGRAM 4:
Two SA-600Ws to
Two-Channel Audio System
for Mono Bass
The SA-600W is great for use in two-
channel audio systems due to its onboard
high-pass crossover. Mono bass in your
stereo system allows greater flexibility in
subwoofer placement.
Using RCA-type cables, connect the
Left and Right stereo outputs from your
preamp to the Left and Right “LINE
INPUTS” of BOTH SA-600Ws. This feeds
a full-range stereo signal into BOTH
amplifiers.
Next, connect the Left and Right
“HIGH PASS OUTPUTS” from ONE SA-
600W (the easiest one to physically access)
to the Left and Right inputs of your
satellites’ stereo power amplifier. This will
feed a high-passed filtered signal (bass
removed) to the Left and Right speakers
once the SA-600W’s internal crossover
(XO) is turned ON. Removing the bass
burden from your satellites will greatly
enhance their performance. See the XO
discussion on page 21 for additional info.
Now that your equipment is
connected, refer to pages 28-31 and follow
the directions for RECOMMENDED
STEREO SYSTEM SETUP
PROCEDURES.
WARNING
WARNING! TURN OFF THE SA-600W(S) AND ALL OTHER EQUIPMENT IN
THE SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
L
R
OUTPUTS
SA-600W REAR CONNECTIONS
PRE-AMPLIFIER
SA-600W REAR CONNECTIONS
SATELLITE AMPLIFIER
Y-ADAPTOR
R
L
INPUTS
