PAGE 89 of 142
DN0108 Rev 00
3.
Once the cable is placed the entire length of tube, bring the zipper
from the opposite end to meet at any point in the middle.
When necessary, the two zippers may be opened to allow any cables to be
routed out of the tube.
5.11.2.3 Clamp Setup
In the event the tube becomes
disconnected from the cable
management clamp, follow these
instructions to reattach the tube
and clamp.
Loosen the clamp screw using
the supplied 3 mm hex driver.
Slide the clamp around the tube
first and then slide the tube
around the outside of the cable
management mount
(Fig. 207)
.
Align the zipper opening and the
cable management clamp
opening.
Slide the clamp over the tube
and cable management mount
pinching the tube in between
(Fig. 208)
.
Tighten the clamp screw
(Fig. 209)
.
Fig. 205 - Zip opposite end
Fig. 206 - Flexible routing
Fig. 207 - Slide tube around mount
Fig. 208 - Slide clamp onto mount
Fig. 209 - Tighten clamp screw
