Installation
(Continued)
REMOVING THE DOOR ASSEMBLY
Figure (3). ...and top of door assembly.
Figure (2). Remove screws from bottom
of door assembly...
Figure (4). Remove the door assembly.
INSTALLING THE LOGSET - TAKE EXTREME CARE - FRAGILE!
Figure (1). Check to ensure ignitor tube is
through the hole in the front log as shown.
Figure (2). Place back log in position.
Figure (3). Igniters fit into cutouts in logs
as shown.
Figure (4). Place front log in position.
Logset components
Back Log
Front Log
Left twig
Right twig
Cross Log
2 pins
Cross Ignitor Tube
(Fixed to front log)
Figure (1). Remove screws from lower
fascia panel at either end. Place panel
carefully aside so as not to scratch or
damage panel.
Figure (5). Place cross log in position by
locating the lugs as shown.
Figure (6). Insert pins as shown through
cross log into front and rear logs.
Derwent High Efficiency Gas Log Fire
6
