JF C-40 S2, Operation & Technical Manual

Page: 8 / 124

8
When operating the machine
Attention:
Whenever there is an instruction in the
manual telling the operator to turn the
machine off and to uncouple the tail shaft
from the tractor, the procedure for re-
coupling the tail shaft and starting the
machine again should occur only at the
end of the operation.
2.1- Avoid grease, oil or dust building-up on the
machine.
2.2- Never feed the machine manually.
2.3- Never attempt to adjust or repair components with
the machine running.
2.4- Do not turn on the equipment without safeguards.
2.5- Loose clothes and long hair might be caught by
moving mechanisms. therefore, never get close or
operate the machine in such conditions.
2.6- Whenever you move the machine out of the
harvesting process, lower the outlet chute.
2.7- Keep the PTO turned on only when working, turn it
off during maneuvers or displacements out of work.
2.8- Never allow unskilled people to operate the
machine or the tractor.
2.9- Do not allow children or other people to get close to
the machine when it is in operation or during
maneuvers.
2.10- Never replace the cutting set gears with the
machine turned on.
2.11- Do not couple the cardan to the PTO when it is
running.
2.12- Do not start or stop the engine with the PTO
running.
2.13- Never remove the stickers from the machine.
2.14- When coupling the cardan for the first time, check
whether its length is proper. See sub-item 7.9.