Before using your computer, you had better complete the following steps:
1. Check motherboard setting
2. Install CPU
3. Install Memory
4. Install Expansion cards
5. Connect Ribbon cables, Panel wires, and power supply
6. Setup BIOS
7. Install software driver & utility
2-2 Checking Motherboard’s Jumper Setting
1. CPU & SDRAM Clock Setting (8-pin): JP1
The motherboard’s CPU & SDRAM memory clock adjusted through jumper JP1.
Table as below:
CPU/SDRAM (MHz)
1-2
3-4
5-6
7-8
66/66
OFF
OFF
OFF
ON
66/100
OFF
OFF
OFF
OFF
100/100
ON
OFF
OFF
OFF
100/133
ON
OFF
ON
OFF
133/100
ON
ON
OFF
OFF
133/133
ON
ON
ON
OFF
2. Keyboard Power On Function Setting (3-pin): JP7
This allows you to disable the keyboard power on function. Set the jumper to
enabled or disabled if you wish to use your keyboard (by pressing < >) to power on
your computer. This feature requires an ATX power supply that can supply at least
300mA on the +5VSB lead. The default is set to disable.
8
