Enter “147+ preview” on keyboard controller to enable the alarm function,
Enter number “148+ preview” on keyboard controller to disable the alarm function,
Attention:
a. Alarm input must be ON/OFF input signal, any other type of input signal (such as power voltage etc)
is possible to damage the unit. When there are alarm signals from multi-channels, the unit will respond
to them one by one, the interval is 2 seconds.
b. Once there is alarm signal coming in, the unit will not respond
to “Scan”, “Cruising” etc functions.
Manual operat
ion is needed to restore “Scan”, “Cruising” etc functions.
c. Whether the alarm function is enabled or not, the alarm output always responds. For example, under
the alarm function is inactive mode, the camera will not move to the position alarm triggered, but the
alarm output still responds.
e. A
2.2KΩ resistor must be connecting for the channel without detector, otherwise the camera will
thinks that there is alarm signal coming in, thus the alarm output is always on.
3-7
Configure the camera module parameter
Key
“145 + Preview” on controller for enter into camera module OSD menu
Key
“146 + Preview” on controller for exit OSD menu
Enter “145 + preview” on the keyboard, then camera module OSD menu will be popped on the the
screen for setting
