The code 140, 141, 142 is special for setup and run a tour group
“142” + “PREVIEW” key for command the camera to tour.
“140” + “PREVIEW” key for programming a tour group.
“141” + “PREVIEW” key for exiting the setup.
For Example, Program
a tour in order to scan 1→2→5→3→4→6 preset (preset 1, 2, 3, 4, 5, 6, was set
successfully). The steps is as below:
1.
Key “140”
+ “PREVIEW” to start a tour setup
2.
Key “1” + “PREVIEW” for the First tour position
3.
Key “2” + “PREVIEW” for the Second tour position
4.
Key “5” + “PREVIEW” for the Third tour position
5.
Key “3” + “PREVIEW” for the Fourth tour position
6.
Key “4” + “PREVIEW” for the Fifth tour position
7.
Key “6” + “PREVIEW” for the Sixth tour position
8.
Key “141”
+ “PREVIEW” to exit tour setup
9.
Key “142”
+
“PREVIEW” to command the camera to tour, the dome camera will be in order
of 1→2→5→3→4→6 to scan.
Dwell time, and more one tour groups setup, please refer the controller menu to do.
3-3 Setup and scan between two points
The user can freely set a beginning point as the Left Limiting Position, an end point as the Right
Limiting Position. Meanwhile, the user can also set the zoom times on the position, the camera only
store the parameters on the beginning point. (Attention: If the beginning point is the same as the end
point, the dome will scan 360°) The operation is as below:
For High speed dome camera(JE900H series)
a. Set up the Left Limited Position: Operate the joystick towards left, adjust the image to the desired
position, then key 130 + Preview on controller
b. Set up the Right Limiting Position: After the Left Limiting position is set up well, operate the joystick
towards right, adjust the image to the desired position, then key 130 + Preview on controller
