Jetter JM-204-480, User Manual, Page: 57 / 126

JetMove 204-480 7.4 HIPERFACE Connection
Jetter AG 57
7.4 HIPERFACE Connection
7.4.1 Specification
Specifications of the Mating Connector for X61 (ENCODER)
• 9-pin male SUB-D connector
• Metallized enclosure
Specification of HIPERFACE Cable
• Cable size: 4 * 2 * 0.14 mm² + 2 * 0.5 mm² (AWG 26(8) + AWG 20(2))
2 * 0.5 mm² (AWG 20(2)) must be used for the power supply unit and for GND.
• Cores have to be twisted in pairs and have to be included in an overall shielding.
• The following signal lines have to be twisted in pairs:
Sine + and reference sine
and reference cosine
DATA - and DATA +
0 V and voltage supply
• The shield must be connected to the connector housings on both ends of the
cable with the greatest possible surface area.
• Material: Copper
• Temperature class: 60 °C
• Max. cable length: 50 m
7.4.2 HIPERFACE cable with mating connector
Note!
The resolver respectively HIPERFACE mating connector of the Jetter motor
series JL, JK and JH and can be ordered from Jetter AG by supplying the
following particulars:
Article no. 15100069 Resolver / HIPERFACE
The complete HIPERFACE cable between the servo amplifier series
JetMove 2xx and the Jetter motor series JL, JK, and JH can be ordered from
Jetter AG. It can be ordered by supplying the cable designation and the
respective cable length in cm:
KAY_0723-xxxx for the digital servo amplifier series JetMove 2xx