Jetter JetWeb JX2-CNT1, User Manual

Page: 88 / 100

13.2 Mode 2 - Operation along with JM-2xx
JetWeb
92 Jetter AG
JetSym - Symbol Listing
JetSym - Program Listing
JetSym ST - Program Listing
2 Define the master axis number.
Procedure: Enter the corresponding number into register 3xx5 "Master
Axis Number".
3 Enable the master position to be output onto the system bus.
Procedure: Set virtual ouput xx003 "Master Position Output".
Register 3xx5 Transmission Rate - Actual Position
Status bit 14 = 1
Register 3xx5: Number of master axis
Function Description
Read Actual master axis number
Write New master axis number
Value range 0; 1 ... 2
In the case of 0 sending is disabled even if virtual
output xx03 is set.
Value following reset 0
SampleProgram A JX2-CNT1module which is located at the first I/O position after the basic device
is to be used as master axis with master axis number 1.
********** Registers *************
rmStatusControl 3003 ; Status / Controller
rmMasternumber 3005 ; Master number
;********** Bit Symbols *************
nbSelectMS_Modus2 14 ;
;
Bit for selecting master/
slave operation
;********** Output Symbols *************
oSendMasterPos 203 ; Virtual output xx03
...
;+++ Initializing Master/Slave Operation in Mode 2 +++
BIT_SET (rmStatusControl, nbSelectMS_Modus2)
REGISTER_LOAD (rmMasternumber, 1) ; Master number = 1
OUT oSendMasterPos
...
//***** Declaration of Variables **************************************
VAR
// Register