• Keep burner at arm’s length, away from face, during ignition. Flame can flare
during ignition.
• Do not attempt to light with included pot or any other cookware on the burner.
Gas build-up can occur, resulting in increased flame eruption.
• Never expose stove to flammable vapors or liquids while lighting the burner. It
can cause an explosion or fire.
• Do not heat empty pot. Product will melt and potentially catch fire.
• Do not move, lift, or tilt stove with lit burner. Product damage or injury can occur
due to flaring.
• Do not fill pot more than half full. This may cause boil-over, resulting in injury.
• If attempting to heat anything other than water, use care and stir frequently to
avoid boil over or scorching, which may result in product damage or injury.
• Always check that the burner is extinguished before disconnecting the fuel canister.
• Do not use for boiling oil or deep frying. Product damage or injury can occur due
to overheating.
WARNING
Preparation:
1.
Remove bottom cover (7.1) from bottom of the Jetboil pot (7.1).
2.
Remove Pack Bag
(if included).
3.
Remove Pot Support Warning Tag.
4.
Add contents to the pot, cover
with lid, but do not put the pot on the stove yet. Now you are ready to light the burner.
5.
Test igniter by depressing igniter button (8.2) until click is heard. If it does not spark,
refer to Maintenance and Troubleshooting sections.
NOTICE
Performance may be suboptimal if used in extreme conditions (cold, hot, wind, altitude).
WARNING
Do not use stove to warm fuel canister. Can result in explosion.
Lighting the Burner:
CAUTION
Ensure burner base is free of any pot prior to lighting. Gas build-up can
occur, resulting in increased flame eruption.
1.
Open control valve (8.1) counterclockwise until fully opened and gas flow can be
heard.
2.
To light, depress Igniter Button (8.2) until click is heard. Repeat as necessary
until ignition (Fig 9).
3.
If ignition does not occur within 5 seconds, close control valves
and wait 5 minutes before repeating the procedure.
Usage:
1.
If necessary, rotate control valve (8.1) clockwise to decrease flame setting.
2.
Once the burner is lit, carefully place the pot with its contents on the burner base
(Fig 10); turn as shown in Fig 11 to lock into place.
CAUTION
Use care when removing lid. Steam and/or contents may be hot and
can cause injury.
OPERATING INSTRUCTIONS
7
Summary of Contents for MICROMO
Page 1: ...Cooking System Instructions MICROMO MINIMO SUMO...
Page 10: ...9...
Page 20: ...19...
Page 21: ...Cooking System Instructions MICROMO MINIMO SUMO I N T E R N AT I O N A L 20...
