Operating Controls
Start/Stop
Power Indicator Light
– The
start switch
has a
power indicator lamp which is
on
whenever
there is power connected
to the shaper, not
just when the shaper is running.
Do not assume
that no light means there is no power to the
machine.
If the bulb is bad, there will no
indication. Always check before use.
Do not rely that no light
means no power to the machine. Always
check for power first. Failure to comply may
cause serious injury!
Referring to Figure 18:
Start
– Press the green start switch (see
Note
).
When power is connected to the machine, the
green light is always on regardless of whether
the shaper is running or not.
Note:
In addition, the switch on the digital
readout must be set to forward (or reverse) and
the cabinet door
must
be closed.
Stop
– Press the red switch to stop.
Reset
– In the event that the shaper stops
without pressing the stop button, as the result of
a tripped fuse or circuit breaker, etc.:
1. Press red button to reset
2. Press the green button to restart the
machine.
Figure 18
Safety Key
The start/stop switch on the JWS-35X Shaper
comes equipped with a magnetic safety key.
When in place on the switch as shown in
Figure 18 the magnetic safety key trips a relay
which will allow the machine to start and stop
when the respective switches are pressed.
Being magnetic, the lock can be removed to
make the machine inoperable and can be
hidden for safe storage by attaching it
underneath the rail or another magnetic surface.
When using the shaper, place the key on the
switch cover lining up the arrow on the key with
the REMOVE arrow on the cover. Then rotate
the key so the arrow lines up with the LOCK
arrow. This will prevent the safety key from
coming loose from vibration when the machine
is in use.
20
Summary of Contents for JWS-35X Series
Page 36: ...Table Assembly Drawing 36...
Page 38: ...Fence Assembly Drawing 38...
Page 42: ...Cabinet and Base Assembly Drawing 42...
Page 48: ...Notes 48...
