4. Work the drive belt down all the way past the
pulleys.
5. Continue sliding the belt down on the left side
until it is free of the bottom
pulley
(E), then
remove the belt over the top of the
motor
pulley
(B).
6. Install the new belt by following these steps in
reverse
Precision Miter Gauge
Setting the miter gauge angle
Referring to Figure 17:
The precision miter gauge has a
rack and pinion
adjustment
for setting the angle. To operate:
1. Slide the miter gauge into one of the slots on
the table top.
2. Loosen
lock handle
(A).
To adjust the
body
(B) of the miter gauge to the
desired angle:
3. Pull
the
spring-loaded knob
(C)
out
and turn
until the
body
(B) of the miter gauge is at the
desired angle as indicated on the scale.
4. Tighten
the
lock handle
(A).
Indent settings
There are indents at the 0º, 30º and 45º right and
left positions. At these settings, release the
knob
(C) to engage the stop rod. Then tighten the
lock handle
(A).
Note:
Do not rely solely on the indents for an
accurate setting. After the stop rod engages at the
0º, 30º and 45º positions, make a fine adjustment
with the
knob
(C) by pulling out and rotating, if
necessary, setting it against the scale indicator.
Extension plate
The
extension plate
(D) can be adjusted by sliding
to the right or left or removed entirely.
To adjust – loosen two
lock handles
(E), position
the extension plate and tighten the lock handles.
To remove – slide the extension plate completely
off and remove the lock handles (E) and mounting
hardware.
Calibrating the miter gauge
1. Place the miter gauge in one of the
slots
(H)
on the table top.
2. Set the miter gauge to 90º (0º setting on the
scale) by loosening the
lock handle
(A), then
pulling the
spring-loaded knob
(C)
out
and
turning the
body
(B) until 0º is indicated on
the
scale
(F).
Figure 17
5. Tighten
the
lock handle
(A).
Verify that the scale indicator (G) reads 0º. If
further adjustment is necessary:
6. Loosen the
screw
(F) and adjust the
indicator
(G) until it reads 0º
7. Tighten
the
screw
(F).
18
Summary of Contents for JWS-35X Series
Page 36: ...Table Assembly Drawing 36...
Page 38: ...Fence Assembly Drawing 38...
Page 42: ...Cabinet and Base Assembly Drawing 42...
Page 48: ...Notes 48...
