Introduction
This manual is provided by WMH Tool Group, Inc. covering the safe operation and maintenance
procedures for a JET Model JWS-35X Series Shaper. This manual contains instructions on installation,
safety precautions, general operating procedures, maintenance instructions and parts breakdown. This
machine has been designed and constructed to provide years of trouble free operation if used in
accordance with instructions set forth in this manual. If there are any questions or comments, please
contact either your local supplier or WMH Tool Group. WMH Tool Group can also be reached at our web
site: www.wmhtoolgroup.com.
Specifications
Model Number
Stock Number
JWS-35X3-1 ..................................................................................................................................... 708323
JWS-35X5-1 ..................................................................................................................................... 708326
JWS-35X5-3 ..................................................................................................................................... 708327
Motor ....................................................................................................................................... Stock Number
3HP, 230V, 60Hz, 1 Phase ............................................................................................................... 708323
5HP, 230V, 60Hz, 1 Phase ............................................................................................................... 708326
5HP, 230V/460V-prewired 230V (for 460V see
Note
below), 60Hz, 3 Phase.................................. 708327
Table Size (L x W)................................................................................................................ 32-1/4" x 26-3/4"
Spindle Size (Standard) ..............................................................................................1-1/4" Interchangeable
Router Bit Collet Size (Optional) .......................................................................................................1/4", 1/2"
Spindle Capacity Under Nut...................................................................................... 1-1/4" Spindle – 4-3/32"
Spindle Travel .............................................................................................................................................. 4"
Spindle Speeds (RPM)........................................................................... 4000, 6000, 8000, 10000, reversing
Table Opening Diameter ....................................................................................................................6-19/64"
Insert Opening Diameters .................................................................................................... 2-9/16", 4-21/64"
Fence Size x 2 .................................................................................................................4-7/8" (H) x 16" (W)
Dust Collection Minimum CFM Required 4" Port...................................................................................... 600
Overall Dimensions .............................................................................32-1/4" (L) x 28-1/4" (W) x 42-3/8" (H)
Weight ......................................................................................................... 550 lbs (Shipping), 475 lbs (Net)
Note:
For 460V operation, magnetic switch (Part No. PM2700-114C) must be purchased separately and
installed. A qualified electrician is recommended.
Optional Accessories
708373
1/4" Router Collet
708374
1/2" Router Collet
708380
1/2" Spindle
708317
3/4" Spindle
708314
1" Spindle
708328
1-1/4" Spindle
708372
30mm Spindle
The above specifications were current at the
time this manual was published, but because of
our policy of continuous improvement, WMH
Tool Group reserves the right to change
specifications at any time and without prior
notice, without incurring obligations.
Unpacking
1. Remove box and wood crating completely
from around shaper. Check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Do not
discard any shipping material until the
Shaper is assembled and running properly.
2. Unbolt the shaper from the skid.
3. Carefully slide the shaper from the pallet
onto the floor.
The Shaper should be placed in an area
with a sturdy level floor, good ventilation and
sufficient lighting. Leave enough space
around the machine for mounting extension
wings and rail assemblies, and loading and
off-loading stock and general maintenance
work.
7
Summary of Contents for JWS-35X Series
Page 36: ...Table Assembly Drawing 36...
Page 38: ...Fence Assembly Drawing 38...
Page 42: ...Cabinet and Base Assembly Drawing 42...
Page 48: ...Notes 48...
