8
Read and understand the entire
contents of this manual before attempting set‐up or
operation! Failure to comply may cause serious
injury.
NOTE: Figures in this manual may show optional
accessories. Depending upon your model, these may
be purchased separately.
6.0
Setup and assembly
Open boxes and check for shipping damage. Report
any damage immediately to your distributor and
shipping agent. Do not discard any shipping material
until the Drum Sander is assembled and running
properly.
Compare the contents of your boxes with the
following parts list to make sure all parts are intact.
Any missing parts should be reported to your
distributor. Read this instruction manual thoroughly
for assembly, maintenance and safety instructions.
6.1
Shipping contents
Box #1:
(see Figure 6‐1)
1
Sander with conveyor table (A)
1
Height adjust handle (B)
1
Hose hanger (C)
2
Socket head screw M6x12 (C1)
2
Flat washer 6mm (C2)
1
Instruction manual
1
Spare parts list
Box #2: Infeed and outfeed tables
(Optional,
see Figure 6‐2)
2
Infeed/outfeed tables (D)
1
Rear (short) fixed bracket (E)
1
Front (long) fixed bracket (F)
2
Folding table brackets (G, H)
1
Hardware package, includes:
4
Locking handles (HP1)
4
Disc washers (HP2)
4
Oilite washers (HP3)
16
Socket head screws M8x16 (HP4)
16
Flat washers M8 (HP5)
4
Socket head screws M6x20 (HP6)
4
Flat washers M6 (HP7)
4
Eccentric cams (HP8)
6.2
Tools required for assembly
5mm and 6mm hex (Allen) wrenches.
Straight edge (such as straight steel bar or carefully
jointed board).
Figure 6‐1: Sander contents (JWDS‐2550‐M shown)
Figure 6‐2: Infeed/Outfeed Tables (OPTIONAL)
