11
Releasing the Cutting Head
When not in use, lock the
cutting head in the down position. Failure to
comply can cause serious injury or damage
equipment.
Unlocking
1. Push down on the
switch handle
(page 9).
2. Pull
out
the
hold-down latch
(A, Fig. 2).
3. Raise the cutting head to the up position.
Locking
Note:
When not in use, lock the cutting head in the
down position.
1. Push the cutting head down
2. Press
the
hold-down latch
(A, Fig. 2)
in
to lock.
Important:
Always use the carrying handles when
lifting or moving to avoid damage to the machine.
Installing the Dust Bag
1. Squeeze the metal
collar wings
(B, Fig. 3) of
the dust bag (A, Fig. 3).
2. Place the dust bag neck opening around the
exhaust port (C, Fig. 3), and release the
collar
wings
(B).
To empty the dust bag, remove from exhaust port,
open zipper on underside of bag and empty into
waste container.
Note:
Check and empty bag frequently. Do not wait
for it to get full.
Installing the Safety Hold-down Clamp
1. Place
the
hold-down clamp assembly
(A, Fig. 4)
in a mounting hole located behind the right or left
fence.
2. Thread
the
hold-down clamp knob
(D) into the
hole located at the rear of the saw base.
3. Tighten
the
hold-down clamp knob
(D).
Saw Blade Wrench
For convenience, a
storage clip
(A, Fig. 5) is
located on the right side of the sliding carriage for
storing the
blade wrench
(B).
Figure 2
Figure 3
Figure 4
Figure 5
