21
same time grasp the
miter handle
(D) and rotate
the miter table left or right to the desired angle.
3. Release the
positive stop locking lever
(C),
making sure the lever snaps into place at one
of the miter stop detents (A).
Note:
The lever will only lock into place at one of
the ten positive stops indicated above
Once the desired miter angle is achieved:
4. Press down on the quick cam
miter table
lock
(E) to secure the table into position.
If the miter angle desired is
not
one of the ten
positive stops noted above:
5. Simply lock the table at the desired angle by
pressing down on the quick-cam
miter table
lock
(E).
Bevel Cut
The sliding fence must be
extended to the left or right when making bevel
cuts. Failure to comply may cause serious injury!
Failure to extend the sliding fence will not allow
enough space for the blade to pass through. This
could result in serious injury. At extreme miter or
bevel angles the saw blade may also contact the
fence resulting in damage to equipment as well as
personal injury.
Tilt the cutting head to the desired angle as shown
on the bevel scale. The blade can be positioned at
any angle, from a 90° straight cut (0° on the scale)
to a 45° left and right bevel. Tighten the
bevel lock
handle
(B, Fig. 26) by pushing down to lock the
cutting head in position. Bevel positive stops are
provided at 0°, 33.9° and 45°.
Note:
The saw comes with a 33.9° bevel detent pin
for setting up crown molding cuts when the angle of
the walls equals 90°.
33.9° Bevel Detent Pin for Crown
Moldings
Note:
A bevel detent pin is incorporated into this
machine for quick bevel adjustments when the
desired bevel angle is 33.9°.
Referring to Figure 27 (except where indicated):
1. Push
the
bevel detent stop pin
(E) in.
2. Loosen
the
bevel lock handle
(A).
3. Rotate
the
cutting head
(D, Fig. 28) until the
bevel detent pin
(E) stops the bevel angle at
33.9° on the
bevel scale
(F).
4. Tighten
the
bevel lock handle
(A) before you
make your cut.
Figure 26
Figure 27
Figure 28
