20
CHARGING YOUR SMART PHONE OR PORTABLE DEVICE
This unit features a 1 AMP USB port on the top of the unit for charging your portable
device (iPod, iPhone, Android phone, etc.) when used with the USB charging cord
that came with your device.
1. Plug one end of the USB cable (not included) into the
USB Charging Port
located on the top panel of the unit. Plug the other end of the cord into the device
you wish to charge.
2. Observe the battery charge indicator on your device to make sure the charging
process starts normally.
3. Unplug the cable when your device is fully charged.
CAUTION:
Before charging, please refer to the user manual of the device you wish to charge to
make sure the charging current requested does not exceed 1A (1000mA).
Overloading the charging circuit may damage the unit permanently and void the
warranty.
1. The USB charging port of this unit supplies a DC 5V output at 1000 mA maximum
current to charge your smart phone or portable device battery and it cannot
support
any other voltage range.
2. Make sure the device you want to charge has a battery charge rating of DC 5V
only.
3. The
USB port of this unit is designed for smart phone or portable device battery
charging only and it cannot support data transfer or connect to computer.
4. Do not connect the USB port of this unit to other external power charger
USB
ports, it may damage both units and void the warranty.
Note:
1.) Some smart phones and portable devices use proprietary USB connections and
circuitry, so they may not charge when plugged into the USB port. Please refer to
your device user manual before you attempt to charge them.
2.) It is normal if the unit gets warm while the USB port is in use and charging your
smart phone or portable device.
3.) Do not charge your smart phone over 12 hours continuously. Disconnect your
smart phone or other portable device from the USB cord once it is fully charged.
USE HEADPHONES (NOT INCLUDED)
Inserting the plug of your stereo headphones (not included) into the headphone jack
will enable you to listen in private. When using headphones, the speakers will be
disconnected.
Read this Important Information before Using Your Headphones
1.) Avoid extended play at very high volume as it may impair your hearing.
2.) If you experience ringing in your ears, reduce the volume or shut off the unit.
3.) Keep the volume at a reasonable level even if your headset is an open-air type
designed to allow you to hear outside sounds. Please note that excessively high
volume may still block outside sounds.
RESETTING
If the system does not respond or has erratic operation, you may have experienced an
electrostatic discharge (ESD) or a power surge that triggered the internal computer to
shut down automatically. If this occurs, unplug the AC adaptor from power source,
wait for 10 minutes, then plug the AC adaptor to power source again. The unit will be
reset, you need to setup the clock, alarm and preset radio channels.
